Tiles larger than 3x3 should be back-buttered with a thin continuous layer of the thin set applied with the flat side of the trowel. Apply as much adhesive as can be covered within 10-15 minutes.ģ/16" or 1/4" square notch trowel should be used when installing our glass material and ridges should be smoothed down with the flat side of the trowel prior to fixing the tiles in the mortar bed.To avoid affecting the color of the tile, white thinset such as Bostik Glass-Mate is strongly recommended for all installations.Plywood should be avoided, since the wood will warp with the added moisture and it will also be less waterproof, even after tiling. Cement board, concrete or drywall is best, as these surfaces can handle the moisture of the tiling process. Before you start tiling, make sure that whatever surface the tiles are being installed to will be strong and structurally sound. *Always use appropriate personal protective safety equipment when handling, drilling, cutting or grinding glass tile such as (but not limited to) eye, ear and hand protection. This is not a factory defect or deficiency of any kind in the material and should be expected by the end consumer. Due to the nature of the material and production process it may be possible to see through the clear glass on certain angles which can appear as a lighter line along the edges of the glass. This will also help you choose which pieces go where, which is especially helpful with tiles that have a lot of variation.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |